Sanyo M-7900 Restored! - 1 November 2026

Discussion in 'Chat Area' started by nickeccles, Nov 10, 2026 at 2:45 PM.

  1. nickeccles

    nickeccles Well-Known Member

    Messages:
    667
    Trophy Points:
    93
    Location:
    Littlehampton West Sussex
    I bought this Sanyo M-7900L recently from eBay as my old one had failed years ago & was beyond repair!

    I didn't expect much for the £60 I paid for it, but it arrived in much better condition than the sellers images suggested & it kind of worked but badly! [​IMG]

    I've spent the last 3 afternoons very carefully removing the whole inside as it comes out as one once the power & FM antenna is unplugged!


    Sanyo M-7900 Restored! - 1 November 2026 (7).jpg Sanyo M-7900 Restored! - 1 November 2026 (7).jpg Sanyo M-7900 Restored! - 1 November 2026 (2).jpg
    First off - New belts as they were stretched & gooey!

    All pots cleaned & all the various switches too.....All were very stiff & did not work as they should!

    Really deep cleaning of the heads & pinch roller, they were all so dirty!
    These are very delicate machines as they really are pretty old.....Look for brittle plastic posts that carry the entire chassis & the posts that hold the whole thing together! I usually put a drop of machine oil in each post making it really easy for the screws to go back in without splitting or fracturing - I learnt this the hard way many years ago!

    This must ba later version of the 7900.....the original versions did NOT have a FG servo inside the motor so the speed can be easily adjusted! A very welcome change from the cetrifugal motor speed motors!

    I also noticed a couple of transistor mountings have been improved leading to them lasting & not failing like in the earlier models!

    Yesterday after putting everything back together, I was greeted with no right channel output [​IMG] It was working headphones when apart!

    As bad luck would have it, I had managed to catch a single wire with a screw that sandwiched the right channel feed to the power amp chip! [​IMG] & of course I had only a tiny length to strip & solder the wire & fit a shrink wrap rubber insulator - Not easy when you're old & eyesight not what it once was [​IMG] I finally managed to do this & after testing before it went back together, I was able to complete a very satisfactory repair on this lovely little radio cassette recorder!

    I don't do many restores these days, although I have a large pile of radio cassettes in my to do cupboard!

    Ah well now Summer is gone, I tend to restore a few until the Spring comes around......

    Et Viola!

     

    Attached Files:

  2. Michiel

    Michiel Well-Known Member S2G Supporter

    Messages:
    291
    Trophy Points:
    63
    Location:
    Europe
    Nice! I remember how everyone was looking for this model, myself included. I eventually managed to find a cheap AKA, though the quality was poor. It’s great that you’ve managed to get a working example again! And a fine repair job, too! Always fun to start tinkering again and to run into those classic, recurring problems, like a pinched wire that ends up keeping everything from working :thumbsup:
     
  3. radiorich

    radiorich Active Member

    Messages:
    286
    Trophy Points:
    43
    Location:
    Washington state
    Absolutely outstanding work,
    Sincerely Richard
     

Share This Page