@Valentin, thank you! Perfect - two things to worry less about.
A quick update: I couldn't completely disassemble the motor, as I didn't want to risk damaging it. Instead, I removed it from the chassis, pulled...
Norm, Unfortunately, this "channel imbalance" you observed is all too common. I often re-record some of my old tapes and run into this exact...
Norm, Good luck with your HK project deck! Those 3 caps pictured are toast :-) As Valentin suggested, low-value electrolytics can be replaced...
Norm, I share the same view as @Valentin and also rely on HPR tapes for a full set and specialty tests (like the AKAI PB 333 Hz 160 nWb/m...
I really hope it doesn't come to that, Norm! I've overhauled both reel motors on my AKAI GXC-760D before, but those were much larger and easier to...
Hi Norm, Thank you for sharing your epiphany. I actually used Flitz (love this product!) on the original player, though not on the donor. Still,...
Norm, Thanks for your help and support, Similar w&f readings from your WM-150 and my WM-2 are interesting … not sure what to make of it, but...
Update: Checking the voltages didn't yield much—nothing matched the values listed in the Service Supplement (except for polarity), though both of...
@JUAN ANDRES MONTIEL DIEZ Thanks for sharing! That screw adjusts the tape-guide height. The head height on both my units is already properly...
Norm, Thanks for the support and the tips. I’ll give your belt-cleaning method a try. Of course, the belt slipped off a couple of times while...
Update: Performed the capstan etching on the donor unit. An interesting (and slightly nerve-wracking) procedure. Unfortunately, it didn't resolve...
No worries, Norm! I’m always happy to help a fellow vintage audio enthusiast, so just let me know if you need that spring. I definitely hear you...
Norm, It really is a WM-2 mystery. After looking through Service Manual Supplement #2 and comparing the schematics against my two units, it’s...
Thank you, Norm! By the way, I meant to ask you if you sorted out the WM-2 Gen 1 missing-part mystery. Alex
Thank you, Norm. I appreciate the tip on checking for belt twists—I learned that lesson the hard way during my first few installations. It’s so...
Scratch that previous update—the correct thickness belts didn't actually help after all. Wishful thinking got the better of my ears on the first...
@JUAN ANDRES MONTIEL DIEZ, send me a PM. It appears there were several modifications after Supplement 2, as both of my WM-2 units vary slightly...
@Valentin, Mechanically—aside from the capstan etching option—I feel I’ve taken it as far as I can. I’ve gone over every potential friction...
Norm, Thanks for the advice on the ferric chloride treatment. I’ve had reservations about chemical etching myself, so I'm holding off until every...
Separate names with a comma.