I see.
Then I don't understand your previous question. I'm fully aware what the switch does, but it is not the root cause of the problem, if it is it...
Flipping the switch on or off does not make any change other than change speed if the knob is off center.
I tried a lot of cassettes, some are better, some are worse but they all exhibit audible W&F, I will take it apart again and do a thorough inspection.
They look fine and they don't wobble when they are spinning.
That's some good news, I will wait for this project then, I will be among the first few to give it a try and give you feedback, I will cancel my...
It looks like the upload function is broken again on this forum, I will upload one when it's fixed.
Please advise, PCBWay came back with out of stock notice, can anyone look at the attached picture and tell me what is the best replacement? Still...
I did not measure the W$F before, but now it's audible, something is wrong but I don't know what it is, I will try to take a video next time with...
No, these are identical to the original parts. Besides, I did not replace the pinch roller just the idler tires.
They can't be larger, they have to fit in their groove.
Back in the 90's I was drooling over the Philips DCC format, particularly the 900 series, I use to read about it in Science & Vie the French...
Well today I hopped on the same boat, I read through the thread and I seem to have the exact problem OP was describing, W&F worsen when the take...
After replacing all 3 rubber tires from this trusted seller I got a horrible wow and flutter, I haven't replaced the pinch roller yet but it...
Here is two videos I posted on YT to illustrate the problem: Pressing record button: [MEDIA] Pressing playback button: [MEDIA]
While servicing the green PCB D6C I noticed next to the record button slider a lever numbered 392 in the service manual Part # X-3305-813-0 LEVER...
Building a new head from scratches would cost thousands of dollars, We were just looking to see if we can find a NOS 1/2" full track head with a...
I don't want to drag this thread into the wrong directions, In short, a year or so ago I was discussing with a fella who's also a mechanical...
I didn't say modern test tapes are trash, I said they are not as good as the factory ones, These home decks making those tapes also are aging...
The lack of test tapes makes me hesitate from attempting such adjustments, The best test/calibration cassettes sold today are made on good home...
Separate names with a comma.