First of all, the flywheel thrust play I wouldn't adjust by measuing the current consumption because that tells nothing about the actual...
Not sure if I can help much further apart from re-stating what I already said. Don't know what the 15 clicks and stop mean and if it means...
The seller won't sell the part unless you want it for the right device. That's interesting, don't think I've ever seen a seller like this before....
If the value is the same, it will work. The DD one looks identical to it. This potentiometer has been used in quite a few devices, it's likely it...
The washer I think is nylon not metal, just a very thick one. Seen these type of non-split washers before (especially on Panasonic walkmans, but...
Some tapes have degradation, even if NOS. Can be related to storage condition or can be related to some batches being worse than others. Seen...
Laser looks ok on camera, since you're looking at it from an angle so won't see the full brightness. I would check the RF level and the shield...
@worldwide137 Electrolytic caps in the range of 100nF - 1uF are still available although rare nowadays. However they don't have to be...
The laser is moving correctly into the ToC position, that's not your problem. Fact spindle motor is accelerating and decelerating, while lens is...
You need to put the resistor in series with the cursor rather than increase the value of R108/R208 to 20k. As for the alkaline vs NiMH, volume...
Make sure the trigger is set to EDGE mode and HOLDOFF is set to off/0. I see HOLDOFF on the screen in your previous pictures. To me it seems the...
There are 2 main ways to fix your problem: increase the series resistors at the output (this will change the frequency response) or to linearize...
DC voltages are close enough to not suspect a problem. Pin 4 may be ok, although unclear what those glitches I see are. On pin 3 (output of FG...
Have you check the FG signal at pin 3 ? Do you have a sawtooth waveform at pin 4 ? What about the reference voltage at pin 5 ?
Have you tried desoldering the PLL bridge ? Also that PLL adjustment trimpot seems to be with the cursor in a position where it's not touching...
Thanks for sharing ! For reference I added a link to your thread to my list of Repair Tutorials under sections "Tutorials by other members":...
The HPR ones from Germany are probably the best bang per buck in terms of calibration tapes. That's what I use myself. There are more expensive...
Indeed this explains why I didn't document the "fix" because there wasn't anything in particular that I've done. Even forgot these units don't...
Glad to hear you found my posts useful. Can't remember for sure if problem was mechanical or electronic, although incline towards being...
I did see this problem once or twice when restoring these models, but just can't remember what I did to fix it as too much time has passed. One...
Separate names with a comma.