Can't remember for sure (didn't disassemble this reel recently), but from memory I would say it can't be pushed from the back. Don't have any...
No, the clutch disc (the part with brass "retainer") has a shaft that is pressed into the reel. Pulling the reel is the way to go, otherwise...
Yes, it will be 3 parts: the lower part of the clutch, the reel, the reel table and the spring. 4 if we consider the spring as a different part....
Indeed the method of installing is not the easiest, but would be interesting to know how the gear works. Regarding removal of clutch, the 2...
Want to make sure I understood the problem correctly. The unit does not play FWD, only REV ? And W&F is high ? Does the unit switch FWD/REV by...
Note the clutch can be disassembled from the reel easily and re-installed after the reel assy has been soaked. In my opinion it's worth trying to...
Given this only thing I can recommend is remove that camgear and lever below clutch, clean them well and re-grease. Sometimes have seen the old...
Looking at the W&F measurements, they actually don't look that bad. I expected to see something like 0.5-0.6% WRMS given the description. Average...
Ok, so first of all it's unclear what you mean by side A. It's better to reffer as FWD/REV, as a cassette can be inserted with face B up, so just...
In the video it can be seen the belt is slipping at the motor. It's also visible it's too thin, looks like a 0.6mm belt, not 0.8mm. Mechanism is...
Yes that point needs to be connected to chassis. Also, as a sidenote, that part of the flex doesn't need to be removed to service the walkman.
Don't know if these retainers are available elsewhere. On that site you need a proxy to buy and a plugin to translate the descriptions in English....
Another thing I should mention is belt can be slipping on some of these Alpha-2 mechanisms. While the original belt is usually still good,...
Yes it will raise the gear on that end, that's what we want in order to increase the clearance. In theory using a washer on opposite end should...
For lubrication use watch oil, the one in the link is fine. And where grease is needed (like the pulley arm) Molykote EM-30L. Yes, this is a...
Have you checked the tilt angle of the head and rollers ? Remove the door and one of the 2 cassette holders and check visually from one side....
Reserved
There aren't many point to lubricate in this mechanism: - motor bearing (in WM-10), however getting oil past the seal can be difficult; - table...
Separate names with a comma.
