Sony Discman D-22

Discussion in 'Discmans, Minidisc, DCC and other players' started by Abhishek Mallik, Nov 6, 2026.

  1. Abhishek Mallik

    Abhishek Mallik New Member

    Messages:
    6
    Trophy Points:
    3
    Location:
    India
    Hi, this is my first post.
    Have been tinkering with my Sony D-22 Discman which I got from a scrap dealer.
    It has all original components. After cleanup, it is spinning the disc but not reading it.
    When I press play, the disc spins about 5 times at 2 sec intervals and the lens is constantly trying to focus. Then it powers off (lcd goes blank). If I press play again, same thing happens.
    The spindle motor is a bit noisy but moves freely. The laser is shinning when seen through a camera and is drawing approximately 37mA, which is quite low I believe.
    Found a few small bad caps. Not leaking but no capacitance. There could be more.
    Could bad caps be causing this issue or is the laser weak?
    Please help.
     
    Last edited: Nov 7, 2026
  2. Jorge

    Jorge Well-Known Member

    Messages:
    1,806
    Trophy Points:
    113
    Location:
    Malibu, CA
    most D-12 have troubles with sled mechanism. Remove laser, remove metal top plate and rotate gears to check that laser moves freely up and down the rail
    OR
    when you desolder sled motor wires - use 1.5V (power supply or AA battery) to check the same

    Which laser does yours have: KSS-162A or KSS-220A? what was the overall shape of D-12 - sometimes they were played 'to death' but it usually shows even before you hit Play
     
    Abhishek Mallik likes this.
  3. Abhishek Mallik

    Abhishek Mallik New Member

    Messages:
    6
    Trophy Points:
    3
    Location:
    India
    The sled is moving freely and the motor is good. The laser is KSS-220A.
    The player was pretty rough from outside being at a scrap dealer, but from inside its good.
     
  4. Abhishek Mallik

    Abhishek Mallik New Member

    Messages:
    6
    Trophy Points:
    3
    Location:
    India
    Sorry, its a D-22, not D-12.
     
  5. Jorge

    Jorge Well-Known Member

    Messages:
    1,806
    Trophy Points:
    113
    Location:
    Malibu, CA
    No, D-22 does not have that sled gears glitch, between D-12 and D-22 Sony must have realized the mistake and made gear teeth bigger (less TPI for the gear rack, otherwise everything looks the same)

    I went through the photos of D-2, D-12, and D-22 that I revived over the years (I just LOVE the looks of these, and sound is pretty decent too) and they all had some bad electrolytics. The photo of one exploded Elna 150uF/16V cap that I posted here a few years ago was actually form D-12!

    So, to figure out why D-22 does not lock on CD you must recap mainboard first. The only shortcut would be to exchange the whole laser mechanism with some working Discman, to see if laser is OK and recap is not a waste of time. Most Discmans from early 90-ies have the same laser mechanism: D-33, D-34, D-36, D-844, etc... even TEAC PD-P3 we discussed last week
     
    Abhishek Mallik likes this.
  6. Abhishek Mallik

    Abhishek Mallik New Member

    Messages:
    6
    Trophy Points:
    3
    Location:
    India
    Thank you Jorge for your suggestion. Recap is exactly what I'm planning to do. The black Chemi-con ones are mostly bad. The Elna ones are still somewhat ok.
     
    Jorge likes this.

Share This Page